【Introduction】： Features and function: ⅠFlux spray system
A function of flux spray device
1 nozzle: import nozzle, better spray
2 air system: AIRTAC electromagnetism valve, anti-corrosive pipe
3 moving nozzle system: air cylinder driven, spray speed and spray
width can be adjusted by handle.
4 filtration flux system: collecting device is made of multi
collecting lay, it is convenient to clean.
5 flux controlling: anti-corrosive controlling flux and display
flux.
B function of flux foam device
With foam function, inner foam pump, it don’t need outer air
supply, it is convenient to spray flux.
1 preheating temperature range: room temperature—260℃
2 controlling way: with PID controlling to make welding process.
3 Heat: infrared heating, temperature uniformity, rapid speed, PID
supply heat.
4 Preheating security: surface temperature is lower than fire point
of flux.
5 Preheat: it can meet preheating need of batch PCB welding,
uniformity temperature, small temperature differences of PCB.
Ⅱ Welding system features:
1 Material: 316 stainless steel
2 Capacity: 100kg double wave crest capacity
3 Height range of wave crest: 0—8mm adjustment and keep wave crest
balance.
4 Power consumption (heater): 6kw, uniformity heat, long life. It
will take 1 hour to melt tin. This can save 6kw during melting tin
and save 3kw during constant temperature.
5 Unique nozzle: double wave crest design, with unique flat wave
which is stable and reduce SMD leaking solder.
6 Heat controlling system: PID control, accuracy is ±2
7 Moving tin pot: in and out can be finished by hand.
8 Motor of wave crest: import motor, running stable.
9 Tin pipe: screw thread stem
import motor The position of tin pot and wave hole
Ⅲ Cooling system
1 Cooling motor: unique cooling design, it can achieve import
device effect.
Transmission system
1 chain: stainless steel chain, anti-corrosive, ametabolic.
2 rail system: special strong aluminum
3 speed: 0—1800mm/min
4 accuracy: motor is from Taiwan, it is easy to adjust and maintain.
Controlling system
1 buttons on the panel: manual/ automatic control, speed can be
set, temperature can be display.
2 protect short circuit: with short circuit protection, with
Sanling air switch protection in main power and tin pot of
preheating zone, with fuse power in controlling system.
3 urgent stop protection: there are 2 urgent stop protection in the
machine, please cut off power in urgent condition.
4 whole machine controlling: relay controlling.
5 transmission speed: Taiwan motor makes sure stable speed.
6 wave crest: Taida transducer makes wave crest flatter.
7 over-current protection: over-current protection with transducer,
it will cut off power when current is over to make motor safe.
8 modularization wiring device: there are main wiring
modularization and controlling modularization.
Technology parameters:
| Specification | TB780D(double wave crest) | 1 | soldertype | lead / common solder | 2 | maxPCB | 50—200mm | 3 | Componentsheight | Above ≤130mm under ≤8mm | 4 | Capacity | 100KG | 5 | Preheatinglength | 600mm | 6 | temperatureaccuracy | ±2 | 7 | spray way | Foam | 8 | temperaturerange | room - 300 | 9 | waveheight | 0—8mm keep balance wave crest | 10 | heatingcontrolling | PID | 11 | speed | 0—180 |
|
